To run the calibration procedure, press the Start key. o The display will show a number for the lowest speed setting (for miles the number should be 0.5). Adjust the low speed setting with the Fast/Slow keys and press Start. o The Speed window will show a number for the top speed setting (for Miles it should be 10.0).Click to see full answer. Consequently, how do I calibrate my treadmill?Press the “stop” key once to access the level two automatic calibration setting and press the “increase speed” until the treadmill speed increases to roughly 80 to 85 percent of the motor usage as indicated on the monitor. Make sure you do not step on the treadmill belt at any point during the calibration process.Similarly, how do you reset the lubricant on a Xterra treadmill? Turn off the main switch on the front of the treadmill, below the motor cover. When “Lube” appears on the LCD check lubrication under walking deck. See the instructions on page 20 to add lube as needed. After application hold PROGRAM for 3 seconds to reset the message. One may also ask, how do I reset my treadmill? Unplug the treadmill for at least 30 seconds. Remove the safety key and plug the treadmill back in. Push the “Reset” button once so that “10” appears on the display. Press the “Enter” button four times, then “Start” once, then “Enter” once more. Replace the safety key. How do you calibrate a NordicTrack treadmill?First, you need to enter calibration mode on the console. To do this, press and hold the STOP and SPEED INCREASE buttons (this will be either an up arrow or a + (plus) symbol). While holding these buttons, insert the safety key onto the console. This will cause the machine to go into calibration mode.